Gravity die casting at Ipoh Castings
Gravity die casting has been our speciality for more than twenty years. Molten aluminium is poured into a reusable steel die and fills it under its own weight – no high pressure – which gives a dense, sound casting that can be heat treated, pressure tested and machined without opening up hidden porosity.
Why we tilt-pour
On our tilt casting machines the die starts horizontal and is rotated to upright at a controlled rate while the metal is poured. The cavity fills from the bottom up, gently, with very little turbulence. In practice that means:
- Less trapped air and gas porosity, because the metal is not splashing into the cavity.
- Less shrinkage porosity, because the casting solidifies progressively towards the feeder.
- Better surface finish and integrity on long-drop parts such as housings, panels and fan blades.
Tilt pouring is not right for every part, so we also run static gravity presses. We will tell you which one suits your design.
Sizes and complexity
We cast parts from small, pure aluminium electrical components up to castings of roughly 1 m × 1 m, with dies up to 1300 × 900 mm on our Stahl tilt machine. Internal passages and undercuts are formed with sand or shell cores, which we make on site.
Metal you can trace
Our aluminium ingot comes from ISO 9002-registered suppliers, with an assay report for each batch. If your drawing calls up a particular alloy or standard, tell us and we will confirm it in the quote.
Typical parts
- Transmission, gearbox and pump housings
- Valve bodies and flow-control parts
- Large fan blades and door panels
- Couplings and brackets for drilling and mining equipment
After casting
Most gravity castings leave us finished, not raw: fettled, heat treated where specified, machined on our 5-axis CNC, and powder coated or anodised through our finishing partners.