When pressure die casting makes sense
In high pressure die casting the molten aluminium is injected into a hardened steel die at high speed and pressure. The die is water cooled, so cycle times are short and every part comes out the same. It is the right process when you need:
- Medium to high volumes – the die costs more than a gravity die, but each part costs less.
- Thin walls and fine detail that gravity casting cannot fill.
- Close dimensional repeatability from part to part and batch to batch.
- A good as-cast surface, often good enough to coat without machining.
Our machines
We run Toshiba 200 t and 250 t cold-chamber machines. That machine size suits parts from a few grams up to medium-sized housings and covers. If your part needs a larger machine, ask us – we can advise whether it should be redesigned, gravity cast or made by a partner.
Typical parts
- Compressor connecting rods and cylinder heads
- Fan blades and fan hubs
- End caps, brackets and housings
- Fencing and architectural hardware
From the machine to your line
Every pressure die casting is trimmed and fettled in house. Many also go through vibratory finishing to remove sharp edges, then on to CNC machining, assembly and powder coating or anodising.
Dies
Pressure dies are made from hardened hot-work die steel. We quote the expected die life in shots up front, so you know what you are paying for and when maintenance or replacement will be due.